STUDY CONCERNING THE CUTTING PROCESS USING A WORM-HOB WITH INCREASED MESHING ANGLE

Mircea MERA

Abstract


The paper presents a comparison between the cutting process using a worm-hob with increased meshing angle and a conventional worm-hob. The paper describes some aspects related to the wearing of the worm-hob with increased meshing angle as compared to the conventional worm-hob, on the basis of the experimental research.

Full Text:

PDF

References


Mera, M., Cercetări privind realizarea unor angrenaje cilindrice cu performanţe ridicate. Teză de doctorat, UTC-N, 2001.

Gyenge, Cs., Petho, L., Mera, M. Manufacturing of Cilindrical Gears With Modified Worm-Hobs. The 10th DAAAM International Symposium Vienna University of Tehnology, Vienna, pg. 177-178, Austria, 21-23 the October, 1999.

M. Mera, Gyenge Cs., Comşa, S, Gears with Profile Crowning and Flanking, International DAAAM Symposium Cluj-Napoca, România, 22 – 24 th. October, 1998.


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :