POSSIBILITIES TO INCREASE THE DURABILITY OF THE ACTIVE PLATES OF THE EXTRUSION DIES

Cristian-Ioan INOAN, Radu-Nicolae CORCHEȘ, Gheorghe ACHIMAȘ

Abstract


Extrusion is the operation of deformation in volume, through which parts with simple or complex con-figurations are executed, based on the plastic flow of the material in the space between the punch and the extrusion plate or through the hole of the extrusion plate.
Active plates for extrusion from molds must ensure the geometry and dimensional accuracy of the parts and be resistant to high stresses in the process of deformation of the material. The problems that arise in the design of active plates from extrusion dies are: determining the pressure, respectively the tensions; establishing the configuration of the assembly and the geometry of the active area.
An increase in the strength of the active plate from the extrusion mold can be obtained by means of shrinkage. It consists of a radial compression of the tube loaded by an internal pressure, through which the maximum normal circumferential tension is reduced. Shrinkage is done by inserting tubes, one into the other, concentric with tightening. Shrinkage can be achieved by the following meth-ods: hot shrinkage; cold shrinkage and shrinkage under cryogenic conditions.


Full Text:

PDF

References


Buzdugan, Gh. Resistance of materials, Technical Publishing House, Bucha-rest, 1970.

Buzdugan, Gh. Resistance of materials, Technical Publishing House, Bucha-rest, 1980.

Cândea, v.ș.a Classification and symboliza-tion of ferrous and non-ferrous alloys, U.T.PRESS Publishing House, Cluj-Napoca, 2010.

Chișu, Alex., ș.a. Machinery Parts, E.D.P. Publishing House, Bucharest 1976.

Deutsch, I. Resistance of materials, E.D.P. Publishing House, Bucharest, 1976.

Drăghici, I., ș.a. Machinery Parts, Problems, E.D.P. Publishing House, Bucharest, 1980.

Gligor, Gh. Extrusion of non-ferrous met-als, U.T.PRESS Publishing House, Cluj-Napoca, 2004.

Manea, Gh. Machinery Parts, Technical Publishing House, Bucharest, 1970.

Păstrăv, I. Resistance of materials, Vol. 2, I.P.C-N. Publishing House, Cluj-Napoca, 1983.

Socaciu, T. Cold reversed extrusion of metals, “Petru Maior” Publishing House, Târgu – Mureș.

Tăpălagă, I. ș.a. Cold Extrusion of Metals, Dacia Publishing House, Cluj-Napoca, 1986.

Tăpălagă, I. ș.a. Cryogenics in the Machine Building, Dacia Publishing House, Cluj-Napoca, 1988.

Tureac, I. ș.a. Ecological design and sus-tainable development with applications in machine building, Transilvania University’s Publishing House from Brasov, 2003.


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :