THE MICRO-FRACTO-GRAPHIC ANALYZE OF EXTRUDED PRODUCTS FROM POLYAMIDE 6.6 REINFORCED WITH GLASS FIBERS

Adrian POPESCU, Liana HANCU, Glad CONŢIU

Abstract


In this paper there are presented the results of the micro-fracto-graphic analyse of the samples from the products obtained after extrusion of polyamide 6.6 (PA 6.6) reinforced with glass fibres. Three different degree of reinforcement are used, respectively 10, 20, 30% of glass fibbers. The micro-fracto-graphic analyse of SEM pictures (scanning electron microscope) is performed and the interdependence between the fibres orientation and the processing temperature during extrusion is presented.


Full Text:

Untitled

References


Plamen G. M., ş.a., Mechanical properties of short fibber reinforced thermoplastic blends, Journal Polymer, nr. 46, pag. 3895–3905. 2005.

Popescu Adrian, Contribuţii privind îmbunătăţirea procesului de extrudare a materialelor compozite polimerice armate cu fibre scurte, Teză de doctorat, Cluj Napoca, Septembrie, 2011.

Popescu, A., Iancău, H., et al, Experimental and theoretic research regarding optimization extrusion process for polymers reinforced fiber (PA 6.6 – 30 % GF), Acta Technica Napocensis, Cluj-Napoca, series: applied mathematics and mechanics Vol.55, IssueI, ISSN 1221-5872, pag. 239-244, 2012.

Rosato, V.D., Rosato, D., Reinforced Plastics Handbook, Elsevier Science; 3 edition, ISBN: 1856174506, New York, 2005.

Thomason, J. L., The influence of fiber length, diameter and concentration on the modulus of glass fiber reinforced polyamide 6,6, Composites, Part. A 39, pag. 1732–1738, 2008.


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :