THEORETICAL AND EXPERIMENTAL RESEARCH ON THE MANUFACTURE OF COMPOSITE STRUCTURES USING RTM PROCESS

IANCĂU Horaţiu, FLOREA Claudiu, POPESCU Adrian

Abstract


This paper aims to highlight the technological features of manufacture of composite structures by the  Resin Transfer Molding process. Polyester resin was injected in a closed mould which had fiber reinforcements disposed there previously. . Measurements were made of tensile resistance for composite parts in an effort to influence the process parameters on these values. Keywords: Composite materials, injection resins, fiberglass.


Full Text:

PDF

References


Advani SG, Flow and Rheology in Polymer Composites Manufacturing. Elsevier, New York, 1994.

Barbero EJ, Introduction to Composite Materials Design,, Taylor&Francis Philadelphia, 1998.

Berthelot JM, Composite Materials, 3 edition, TEC & DOC, Paris, 1999.

Gay D, Composite Materials, 4th edition, Hermes, Paris, 1997.

Gibson RF, Principles of Composite Materials, Principles of composites materials mechanics, McGraw-Hill, Inc. New-york, 1994.

Ianca H, Nemes O, Composite materials. Design and manufacture, Publisher Mediamira, Cluj-Napoca, 2003

Iancau H, Tero M, Contribution concering the resin transfer in the RTM procedure of producing composed material device. Iasi, Fifth International Scientific Conference "Modern Technologies, Quality, restructuring TCMR-2002" 23-25 May 2002, University Gheorghe Asachi.

Tero M, Composites made by RTM process. Cluj-Napoca, Napoca Star, 2006.


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :