IMPROVING THE DESIGN OF PLASTIC ANCHORS FOR POLYSTYRENE

Călin NEAMȚU, Radu COMES, Remus BOLBA, Rareș Adrian GHINEA

Abstract


The paper presents the redesign process of the plastic anchor used for polystyrene walls. This process is based on the information obtained within a focus group and an extended analysis of the products available on the Romanian market. After the redesign process was completed the design process of the mould required to produce the plastic anchor has been developed and analysed. The redesign anchor obtained using this mould has been validated using dimensional measurements and visual inspection.

Key words: redesign, polystyrene, plastic anchor, mould design


Full Text:

PDF

References


Seres I. Matrite de injectat in exemple, Editura Imprimeriei de Vest, ISBN 9739329047, Oradea, 1998,

Haitian Company, Technical specification of Hatian Mars II series , available on-line at http://www.haitian.com/en/products/mars_2_series/

Opran C. Tehnologii de injectie in matrita – indrumar de proiectare, UPB, Bucuresti, 2009

Rees, Herbert, Understanding injection mold design, Hanser Publishers, ISBN 3-446-21587-5, Munich - Cincinnati, 2001

Malloy R.A. Plastic Part Design for Injection Molding - 2nd Edition, Hanser Publishers, ISBN 978-1-56990-436-7, Munich - Cincinnati, 2010


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :