CUTTING EDGE PREPARATION FOR TWISTED DRILLS

Vlad-Bogdan TOMOIAGĂ, Marcel Sabin POPA

Abstract


Abstract: To obtain better results for tool life, researchers have improved the microgeometry of the cutting edge. Through cutting edge preparation, a defined rounding and a reduced chipping of the cutting edge can be achieved. For this paper, twisted drills with the K factors: 0.5; 1 and 1.4 were used. The preparation process to obtain the K factors above was micro abrasive jet machining and drag finishing.
Key words: Drill, K Factor, Cutting edge, Micro geometry, Surface integrity

Full Text:

PDF

References


Biermann, D., Terwey, I., Cutting edge preparation to improve drilling tools for HPC processes, CIRP Journal of Manufacturing Science and Technology 1 pp 76-80, 2008

Cortes, R., Cutting Edge Preparation of Precision Cutting Tools by Applying Micro-abrasive Jet Machining and Brushing, (PhD Thesis) Universität Kassel, Kassel University Press, Kassel, 2009

Denkena, B., Luis de Leon, Bassett, E., Fünf-Achs-Bürsten zur Schneidenkantenpräparation, ATZproduktion 01/2009 Jahrgang 2, 2009

Tikal, F., Bienemann, R., Heckmann, L., Schneidenkantenprepräparation Ziele, Verfahren und Messmethoden, Berichte aus Industrie und Forschung, Kassel: Kassel University Press 2009 [in German language]

Denkena B, Lucas A, Basset E. Effects of the cutting edge micro geometry on tool wear and its thermo- mechanical load, CIRP Journal of Manufacturing Science and Technology 2011; 60:73–6.

Denkena, B., Köhler, J., Rehe, M., Influence of the Honed Cutting Edge on Tool Wear and Surface Integrity in Slot Milling of 42CrMo4 Steel, Procedia CIRP 1 190-195, 2012

Denkena, B., Köhler, J., Ventura, C.E.H., Customized cutting edge preparation by means of grinding, Precision Engineering 37 590-598, 2013

Denkena, B., Biermann, D., Cutting edge geometries, CIRP Annals – Manufacturing Technology 63 631-653, 2014

Denkena, B., Köhler, J., Breidenstein, B., Abrao, A.M., Ventura, C.E.H., Influence of the cutting edge preparation method on characteristics and performance of PVD coated carbide inserts in hard turning, Surface&Coatings Technology 254 447-454, 2014

Biermann, D., Denkena, B., Komplettpräparation von komplexen Zerspannungswerkzeugen III, Abschlussbericht des Projektes, 2014

Fulemova, J., Rehor, J., Influence of Form Factor of the Cutting Edge on Tool Life during Finishing Milling, Procedia Engineering 100 682-688, 2015

Ventura, C.E.H., Köhler, J., Denkena, B., Influence of the cutting edge geometry in intrerrupted hard turning, Journal of Manufacturing Processes 19 129-134, 2015


Refbacks

  • There are currently no refbacks.


JOURNAL INDEXED IN :